Finding your size
Every hair ring is made to order in one of four sizes, following the circumference of the head where the ring rests. One measurement, taken in a minute, is all it requires.
How to measure
The ring follows one path around the head. Seen from the front and from behind, it is the same line.
A front hairline · B one centimetre above the ear · C under the occipital bone
If your hair is long, gather it into a ponytail set high on the crown, so the tape can follow the head itself.
Begin at the front hairline, or just below it (A). Pass the tape behind each ear, about one centimetre above where the ear meets the head, never over it (B), and under the occipital bone, the small ridge at the back of the skull (C).
The tape should sit close against your head and follow its natural outline without squeezing. You should not feel any tightness while measuring. Note the measurement in centimeters. Measure twice and use the larger figure.
Your size
Enter your head circumference.
Between two sizes, choose the larger.
Three ways to wear it
The same measurement serves all three. Only the hair beneath the ring changes.
Set behind the front hairline, the hair at the back falling over the ring.
Resting on top of the hair, tilted slightly back. So light it disappears.
Across the middle of the forehead, over loose hair.
The right fit
Worn as a headband, the ring rests without pressure. At the back, under the occipital bone, there should be room for about one finger, the space the head needs for comfort and movement.
Worn over the hair, as a crown or across the forehead, it should sit so lightly you barely feel it.
Made to your measure
Each ring is sewn by hand to the size you order and shipped within one to two weeks. Because every piece is made to order, we do not accept returns, except for a defective piece.
If the fit is not right, write to us. We will look at an exchange case by case.
Prefer to try before deciding? Ask us about a sizing kit.